Introduction To Authentication With Contacless Card; Selecting The Type Of Contactless Card To Be Supported; Recognition Modes; Morpho Access ® J Series - Sagem Securite MorphoAccess J-Bio User Manual

Automatic fingerprint recognition terminal, j series

Table of Contents

® J S

– User Guide

ORPHO

CCESS

ERIES

1. Introduction to authentication

with contacless card

Selecting the type of contactless card to be supported

Recognition modes

DOCUMENT SSE-0000077399-01 - V

AGEM

ÉCURITÉ

OCUMENT

On MorphoAccess

J Series terminal equipped with a MIFARE

contactless smartcard reader (see section Scope of the document), the type of

contactless smartcard enabled are defined by the following specific

configuration key:

Enabled profiles

app/contactless/enabled profiles

•

0 means " default mode (MIFARE

•

1 means " Support of DESFire

•

2 means " Support of MIFARE

•

3 means "Support of both DESFire

It is then necessary to configure the parameters listed in the next sections so as

to set the wished recognition mode using contactless smart card. Note that

when app/contactless/enabled profiles key is set to 0 and the parameters listed

in the following sections are configured so as to set a recognition mode using

contactless smartcard, MIFARE

For terminal configured for MIFARE

the document), it is only necessary to configure the parameters listed in the next

sections so as to set the wished recognition mode and enable MIFARE

reading at the same time (i.e. set that key to 0).

Various recognition modes using contactless card can be applied depending on

the fingerprint templates location (user's contactless card or terminal database)

and the required security level.

Recognition with DESFire

(depending on configuration) card containing some structured data (identifier,

biometric templates...).

1.0 - M

ERSION

- R

EPRODUCTION AND

ISCLOSURE