Table of Contents
Advertisement
AMC FRONT PANEL
POWER Switch – Turns AMC on and off.
USB 2.0 Connector – used for updating firmware in the AMC rack and the AMC Control program.
STATUS / POWER LED – Indicates the AMC is powered. When flashing indicates internal
microcontroller is operating normally.
AMC REAR PANEL
1.POWER
The AMC has switching power supplies that operates on 100-230 VAC 56/60 Hz. No voltage
change switch required. Standard IEC 3 pin power connector.
2.CHANNEL ASSIGNMENTS
The AMC I/O connections use DB25 connectors wired to the TASCAM/ Avid protocol for both
analog and digital. These DB25 cables are not supplied.
The channel assignments are SMPTE standard
1. Left
2. Right
3. Center
Page 7
Advertisement
Table of Contents
