Table of Contents
Advertisement
REMOTE AUX RS232 - Connects the remote to a 2
THE MENU
Menu Switch – enters the menu mode and switches between scroll and parameter modes.
In the Scroll mode, the gain control "scrolls" through the menu items.
In the Parameter mode, the gain control changes the selected parameter. To switch between
modes, tap the menu key. The current mode is displayed at the bottom of the display.
Dim/Cancel switch - exits the menu mode and stores the changed values in the current preset.
Preset Buttons – when the remote lock out is on, used to input access code.
An example of using the MENU to change the left calibration to +3 dB.
1. Tap the menu switch.
2. Rotate the gain control to cycle through the menu items to left calibration.
3. Tap the menu switch to enter parameter mode.
4. Rotate the gain control CW or CCW until the display reads +3.0 dB.
5. Tap the menu key to go back to scroll mode.
6. Tap the dim/cancel switch to exit the menu and store the preset.
7. To change multiple items, follow 1-5 on each parameter and then hit the dim / cancel key
when you have completed all your changes.
MENU ITEMS
1. Channel Calibration – sets the output gain offset for the selected channel. Used to balance
channel levels.
2. Channel Delay – sets the time delay for the selected channel. Channel delay is used to
time align each speaker to compensate for the unequal distances between the listener and
the speaker. For example, a subwoofer is usually farther away from the listener than the
front speakers, so the sound from the subwoofer arrives later than the sound from the front
speakers. In this case you would add additional time delay to each of the front speakers to
time align with the subwoofer. The time delays of each speaker can be measured using the
nd
AMC rack for 16 channel operation
Page 12
Advertisement
Table of Contents
