Starting The Sro Program - BLUE SKY AUDIO MANAGEMENT CONTROLLER Manual

STARTING THE SRO PROGRAM

Once the AMC Control program is running, click the SRO button in the right hand corner of the
main screen. The following screen will pop up.
This screen shows the current state of the EQ, target filters, measured frequency response and
corrected frequency response of all the channels. Clicking on any of the small graphs will open up
a larger graph.
Measure- measures the selected speakers. You must have at least one speaker selected for the
measure button to be active.
Optimize - Starts the optimization process on the selected the speaker response to the target
curve. You must measure the speaker before the optimize button is active.
Clear EQ - clears the EQ on the selected channels.
USB audio in - shows a compatible audio USB interface input, normally the ART Dual Pre
USB audio out- shows a compatible USB audio interface output normally the ART dual Pre
Page 33