Table of Contents
Advertisement
THE AMC CONTROL SOFTWARE
The AMC Control Software is available in two versions One is 32 bit Windows program that will run
on both 32 and 64 bit versions of Windows 7, 8, and 10. The second is a OS X version that will
run on Yosemite, EL Captain, and High Sierra. This program and is intended for use only with the
Blue Sky AMC and will not run without the AMC is connected to the computer by USB.
Both versions of the AMC Control software are available for download. Contact Blue Sky for a
download link.
INSTALLING THE AMC CONTROL SOFTWARE IN WINDOWS
Download the setup program and save it to your computer at a location where you can find it.
Double-click of the setup program to install it. The installer will create a folder under the program
files (0x86) called Blue Sky and install the program in that folder.
INSTALLING THE AMC CONTROL SOFTWARE IN OS X
Download the zip file and unzip it to your desktop or application folder.
RUNNING THE PROGRAM
Turn on the AMC and wait unit the red LED on the front of the AMC is flashing approximately once
every two seconds and the remote mute button is lit..
Plug the USB cable into the front of the AMC. If this is the 1st time you have connected the AMC to
your computer you may see a message that says USB detected, installing software. Wait till the
computer is done and the LED on the front of the AMC goes back to flashing.
If everything is connected you should see the Main Screen:
Page 17
Advertisement
Table of Contents
