Setting The Scsi Id From The Remote Management - Quantum Tape Drive Scalar 50 Installation Instructions Manual

Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-01 B01
September 2007
Figure 11 Host Bus
Options Screen
Figure 12 Drive
Operations Screen
Setting the SCSI ID
from the Remote
0
Management Pages
12
4 Use the up and down arrows to highlight the tape drive receiving the new
SCSI ID and press
Enter
5 Use the up and down arrows to select a SCSI ID and press
ID.
6 When you have completed setting the SCSI IDs, press
screen.
Cabinet
7 From the screen, use the up and down arrows to highlight
Ops
and press
Operations
The
Drive Operations
8 Use the up and down arrows to select a tape drive and press
9 Use the up and down arrows to select
The tape drive powers down and returns to the
10 Use the up and down arrows to select
The tape drive powers on and is ready for use. The tape drive installation
is complete.
To set the tape drive SCSI ID on a Scalar 50 Series library from the remote
management pages:
The library must be off-line during this procedure.
Note:
1 On the host computer, open the internet browser software.
2 In the field, type http://IPaddress/ where IP address is the IP
Address
address for the Quantum Scalar 50 Series library.
Setting the Tape Drive SCSI ID
.
.
Enter
screen displays (see figure
and press
Off
and press
On
to set the
Enter
to return to the
Exit
Drive
12):
.
Enter
.
Enter
screen.
Drive Operations
.
Enter