Completing The Native Fibre Channel Installation - Quantum Tape Drive Scalar 50 Installation Instructions Manual

Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-01 B01
September 2007
Figure 15 Drives Page
Drive operations

Completing the Native Fibre Channel Installation

14
6 To change a SCSI ID, enter the ID number in the field next to the device
and click .
Apply
7 From the
Operations
The page displays (see
Drives
8 Enter the new tape drive number
9 Select and click
shutdown
The tape drive powers down.
10 Enter the new tape drive number
11 Select and click
Power on
The tape drive powers on. The tape drive installation is complete.
Note: The firmware revision on the new tape drive(s) must match the
firmware revision on the currently installed tape drives (of the
same tape drive type). If the new tape drive has a different
revision, you must download the appropriate tape drive firmware
from Quantum and update the drive. All tape drives in the library
must contain the same firmware revision. You can view the tape
drive firmware revision on the OCP under
After native Fibre Channel tape drives are installed, additional information
must be gathered to complete the installation and verify connectivity.
Competing the native Fibre Channel tape drive installation consists of the
following steps:
Completing the Native Fibre Channel Installation
page, click on the
Drives
figure 15):
.
Apply
.
Apply
tab.
.
Drive Operations
0