Quantum Tape Drive Scalar 50 Installation Instructions Manual page 19

Figure 21 Nsshow
Command
• Connect Via a Web Browser
Note: The information below applies to a Brocade SAN switch. For other
SAN switches, contact the SAN administrator.
Connect Via a Telnet Session
To connect via a Telnet session to a SAN switch:
1 Connect the service laptop to the SAN switch using an Ethernet cross-
over cable, or by connecting to the LAN (if available).
2 On the service laptop, open a command prompt window.
3 From the command prompt, enter the following command and press
<Enter>:
telnet <IP address of SAN switch>
The SAN switch login prompt displays.
4 Enter the
username
Note: For Brocade SAN switches, the default login is admin for the
username and
changed by the system administrator. For all other switches,
contact the system administrator.
5 For Brocade switches, at the command prompt, type
<Enter>.
The nsshow command displays (see
WWN for the library
Completing the Native Fibre Channel Installation
Quantum Scalar 50 Tape Drive Installation Instructions
and and press <Enter>.
password
for password. This may have been
password
figure 21).
WWN for the second
Native Fibre channel
drive
Document 81-81769-01 B01
September 2007
and press
nsshow
WWN for the first
Native Fibre channel
drive
19
0