Required Tools; Unpacking The Tape Drive; Installing The Tape Drives - Quantum Tape Drive Scalar 50 Installation Instructions Manual

Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-01 B01
September 2007
0

Required Tools

Unpacking the Tape Drive

Installing the Tape Drives

6
The following tools are required to perform the tape drive upgrade
procedure:
• Flat blade screwdriver
Caution: Use appropriate electrostatic discharge (ESD) precautions
when installing the tape drive.
To unpack the tape drive:
1 Open the shipping carton.
2 Remove the tape drive from the carton.
The tape drive is protected by two pieces of foam and an antistatic bag.
3 Remove the foam from the wrapped tape drive. Remove the tape drive
from the antistatic bag.
To install tape drives in a Scalar 50 Series library:
If this is an initial library installation, it is recommended to turn
Note:
the library off prior to installing tape drives. If this is an existing
library that is receiving a tape drive upgrade, the library can
remain powered on.
Each tape drive ships from Quantum with a version of library
Note:
firmware as well as drive firmware on the tape drive interface
PWA. When you install the tape drive, the library will check the
version of library firmware on the tape drive and verify if the
firmware is newer than the version currently running. If the
library firmware on the tape drive is newer than the version
currently running on the library, the OCP will prompt you with
the option to upgrade the library firmware.
1 At the back of the library, use a flat blade screwdriver to loosen the
captive screws that secure the cover plate to the empty drive bay.
2 Set the cover plate aside.
Unpacking the Tape Drive
0
0