Setting The Scsi Id - Quantum SDLT 600 User Reference Manual

C3
3
3

Setting the SCSI ID

This section describes how to set the SCSI ID on the tabletop
tape drive. For information about setting the SCSI ID on an
internal tape drive, refer to the SDLT 600 Product Manual.
Each device connected to a SCSI bus must have a unique
SCSI ID number. The factory preset SCSI ID is 3 for the
tabletop tape drive and 5 for the internal tape drive. Ensure
that your tape drive's SCSI ID is unique on your SCSI bus.
You can change the SCSI ID using the push-button switch on
the back of the tape drive. Use the point of a pencil to press
the buttons above or below the number display to increase or
decrease the ID number.
!
If the tape drive is the only SCSI device, leave the SCSI ID
set to 3, the default setting.
!
Do not use a SCSI ID of 7. This setting is typically
reserved for the SCSI controller.
C3 | Setting the SCSI ID