Main Landing Gear Assembly And Installation; Installing Guided Missiles And Pylons - Freewing FJ3021 User Manual

Main Landing Gear Assembly and Installation

Main landing gear accessories list:
A. Trunion
B. Grub screws (M3*s 3pcs)
C. Main gear metal pin
D. Main gear main strut
E. Grub screws (M3*3 2pcs)
F. Spring
G. Main gear dampening strut
H. Pin
I. Screws (PM*6 2pcs)
1.lnsert the "Main gear metal pin(C)" into the
"Trunion(A)", and secure it with "Grub screw(B)".
2.Put the "Main gear main strut(D)" to the "Main gear
metal wire(C)", and lock it with "Grub screw(E)".
3.Use "Pin(H)" to connect the "Main gear main strut
(D)" to the"Main gear damping strut(G)".
4.Use "Grub screw(B)" to secure the flat side of the
" Wheel shaft(L)" to the "Main gear damping strut
(G)", then put the" Nut(J)", "Wheel(K), "Collar
lock(M)" onto the "Wheel shaft(L)". Finally use
"Grub screw(E)" to secure the "Collar lock(M) ".
5. Use "Screws(I)" to attach the "Spring(F)" to the
"Main gear damping strut(G)" and "Main gear
gear main strut(D)".
6.Place the "Main gear assembly(O)" on the "Main
gear mount(N)", and use 2 "Screws( P)" and 2
"Screws(Q)" to secure it in place..
,&
Note:
When installing, please check that the flat
position of part is aligned with the screw before tightening.
The flat position must face the screw hole so that it can lock
in place properly. Failure to do so can result in the piece
being misaligned, or worse, falling off.
Installing the Guided Missiles and Pylons
1. Refer to the photo on the right for the proper
positions for the Pylons and Missiles.
2. Use the glue where the arrows indicate and
attach the pylons into the slots on the wings.
3. Allow at least 2 hours for the glue to dry.
4. After the glue has dried, install the guided
missiles as indicated.
F/A 18E Super Hornet
Item No.: FJ3021
Version No.: FJ3021-V02
J. Nut
K. Wheel
L. Wheel shaft
M. Collar lock
N. Main gear mounting point
O. Main gear assembly
P. Screws (PWA3*10 2pcs)
Q. Screws (PWA3*45 2pcs)
H
A
-... .. . . . • L . . . .
C
B
-6-
EN