Vector Mix Setup - Freewing FJ3021 User Manual

Vector Mix Set Up
EN
Note: This jet has the vector function, a 7CH+ programmable radio is required.
1. Connect the left up/down vector control servo to the 7th CH in the receiver
2. Connect the right up/ down vector control servo to the 8th CH in the receiver.
3. Use Y-harness to connect the left and right vector control servo and nose wheel steering servo, then, insert the Y-harness
into the rudder channel (4thCH) in the receiver.
4. Enter into the PROG. MIX from radio menu, set the mix for 7CH to elevator and aileron.
5. Enter into the PROG. MIX from radio menu, set the mix for 8CH to elevator and aileron.
Vector-Elevator mix
Stick Forward
Stick Back
Vector-Aileron mix
Stick Right
Stick Left
•
Vector-Rudder mix
Stick Right
Stick Left
F/A 18E Super Hornet
-10-
Item No.: FJ3021
Version No.: FJ3021-V02