Table of Contents
Advertisement
Nose Landing Gear Installation
Nose landing gear spare part list:
A - Electric retracts
B - E-Clip
(02.0mm)
C - Nose landing gear steering pushrod D -
Nose landing gear steering control ring E -
Trunnion
F - Nose landing gear strut
G - Steering tiller
H - Screw
(PT2.6.6mm)
I -Wheel
J -Wheel lock bolt
K- Grub screw
(M3*3mm)
L - Nose landing gear set
M - Screws
(PA2.G·1omm)
N - Nose gear mount
1.Put the "Steering tiller (G)" and "Landing gear rotating
arm(E)" in the "Landing gear metal wire (F)".
2.Snap the "E-clip(B)" on the notch of
"Landing gear metal wire (F)" to secure it.
Use"screw (H)" to anchor the "Steering tiller(G)".
3.Put the "nose landing gear steering control
ring (D)" on the "Nose landing gear steering push
rod (C)", and screw the threaded end of"Nose
landing gear steering pushr od( C)" to the
"Steering tiller (G)".
4. Put the "wheel( "I)and "Wheel lock bolt (J)" to the
bottom of "nose landing gear strut (F)", and use
"Grub screw(K)" to secure the "Wheel lock
bolt( J)".
5. Place the assembled "nose landing gear ( ( L)" on
the "nose gear mount (N)". and use "screws
(M)" to secure it.
Note:
when installing, please check the flat
position of applicable parts, when screwing a
part to seat properly, the flat position must face
the screw hole. If they are not seated properly,
they may fall off.
Main Landing Gear Installation
Main landing gear spare part list:
A- Electric retract
B - Grub screw
(M3·3mm)
C - Main landing gear metal strut
D-Wheel
E -Wheel lock bolt
F - Grub screw
(M3*3mm)
G - Rear landing gear set
H - Screws
(PA2.6•1omm)
I - Main gear mount
1.lnsert the"Main landing gear metal strut (C)"into the"Electric
retract( A)", and use "Grub screw ( B)," to secure it.
2.Put the "wheel( D) " Wheel lock bolt( E)" to the "Main landing
gear metal strut(C)", and use" Grub screw (F)" to secure
the" wheel lock bolt ( F)".
3.Place the main landing gear assembly (G) on the
"Main gear mount (I)" and secure it with "4 screws (H)".
& Note:
When installing, please check the flat
position of applicable parts, when screwing a part
to seat properly, the flat position must face the
screw hole. If they are not seated properly, they
may fall off.
Rebel 70 EDF Jet
Item No.: FJ20311
Version No.: FJ20311-V01
, , � m
VJ®J. . . . . . . . .
E
D
· ·· · · l· · · · � ..,,r( · · ·· ·· · ·· · ··
��.
-4-
�--
-K
i
J
B
��
A_
�
H
EN
M
C
,,,,,,.
- - - · ·
.
B
81
Advertisement
Table of Contents
