Table of Contents
Advertisement
Elevator Servo Installation
Referring to the diagram on the right:
A. Plastic cover
B. Screws
(PWA2*8 2 pcs)
1.As shown by the arrow, press the 9g servo
into the servo bay.
2.Use 2 "screws(B)" to secure the servo to the
wooden piece.
3.Glue "Plastic part (A)" to the fuselage to
cover the servo.
Elevator Installation
A. Screw
B. Aluminum collar
C. Arrow
D. Rotating shaft
1.Put the "aluminum collar (B)" in the slot as the
"arrow (C)" shows.
2. Insert the elevator into" Rotating shaft (D)".
3.Use "screw (A)" to lock the "aluminum collar (B)"
to the" rotating shaft (D)".
A�
Screw one threaded side of push rod (A) into the ball link clevis
head(B). Turn it left or right to increase or reduce the length of
the push rod.
1.Put the ball head(A) onto the screw (B),
then insert the screw (B) through the
-�,
hole of control horn( D ) , and lock it with
nut (C).
D
FM�•10
Nose Cone Installation
1.Use glue to attach the nose cone to the
fuselage.
F/A 18E Super Hornet
Item No.: FJ3021
Version No.: FJ3021-V02
Elevator push rod size
----
bD
90 mm (3.55 in)
r"l � f----
Elevator pushrod mounting hole
f�= === ===c/b,<E �
2
:•· · ······•(6)
EN
I
Pushrod Diameter: 01.2mm
►
n
2
1z
3
�
Advertisement
Table of Contents
