Baseboard Management Controller; Table 10. Video Mode - Intel S2400SC Technical Product Specification

Functional Architecture

In the dual mode (on-board video = enabled, dual monitor video = enabled), the on-
board video controller is enabled and is the primary video device. The add-in video card
is allocated resources and is considered the secondary video device. The BIOS Setup
utility provides options to configure the feature as follows:
On-board Video
Dual Monitor Video
3.4.3

Baseboard Management Controller

The server board utilizes the following features of the embedded baseboard management
controller.

IPMI 2.0 Compliant

400MHz 32-bit ARM9 processor with memory management unit (MMU)

Two independent10/100/1000 Ethernet Controllers with RMII/RGMII support

DDR2/3 16-bit interface with up to 800 MHz operation

12 10-bit ADCs

Fourteen fan tachometers

Eight Pulse Width Modulators (PWM)

Chassis intrusion logic

JTAG Master

Eight I2C interfaces with master-slave and SMBus* timeout support. All interfaces are
SMBus* 2.0 compliant.

Parallel general-purpose I/O Ports (16 direct, 32 shared)

Serial general-purpose I/O Ports (80 in and 80 out)

Three UARTs

Platform Environmental Control Interface (PECI)

Six general-purpose timers

Interrupt controller

Multiple SPI flash interfaces

NAND/Memory interface

Sixteen mailbox registers for communication between the BMC and host

LPC ROM interface

BMC watchdog timer capability

SD/MMC card controller with DMA support

LED support with programmable blink rate controls on GPIOs

Port 80h snooping capability

Secondary Service Processor (SSP), which provides the HW capability of offloading time
critical processing tasks from the main ARM core.
44

Table 10. Video mode

Enabled
Disabled
Enabled Shaded if on-board video is set to "Disabled"
Disabled
Intel order number G36516-002
Intel® Server Board S2400SC TPS
Revision 2.0