Power Up; Temperature Setpoint - Salus FC600 Instruction Manual

2.4 Power Up

After the Fan Coil (FC600) has been installed accordingly to your system (for the installation and different
systems description please refer to the Installer Section in chapter 4) it will go into STANDBY Mode. To start
using your FC600 and adjust room temperature, create schedules and operate the fan you will need to wake
it up. Simply press the
settings. The time should be 12 AM. Note: Press any button to activate the LCD first!
Note: By default, if you are using the thermostat without the Internet, it will be non-programmable, meaning
that you cannot set programs. The thermostat can be switched to programmable mode by changing the d00
parameter from 0 to 1 in Installer Mode. Find more information in the Installer Section.

2.5 Temperature Setpoint

Setpoint temperature is the temperature you want to set or the temperature set by the program. Under your
home display, press
short press of the Up/Down arrows, the LCD will show the current program setpoint, with the Set icon.
For non-programmable thermostat
M
Press arrows to check setpoint
9 Fan Coil FC600 Instruction Manual
button for 3 seconds. The icons on your screen will show up depending on your
M
or to view the set point temperature. When the program is running, after the
The current setpoint temperature
will start flashing
The thermostat will now return to home screen and it will follow new setpoint.
M
3 sec
M
Press Up/Down to increase/
decrease setpoint
M
.
M
Press OK to save and exit
M