Salus FC600 Instruction Manual page 12

3.
M
M
4.
M
M
M
When thermostat operates in Eco Mode, you cannot set a new temperature set point by pressing the
After thermostat exists Eco Mode, it returns to the previous set mode.
The default set point temperature is 30°C for cooling mode and 15°C for heating mode. To change that, please
refer to settings in Installer Section.
Note: If you have the occupancy sensor, then the Eco Mode will be activated automatically when the
set up is complete. This is the default setting. You can choose from either ECO or STANDBY mode when
depending on the position of the keycard (in/out).
If your thermostat is set to Auto Heat/Cool selection, these are the 2 possible combinations you can have by
short pressing the Mode Button:
1.
M
M
2.
M
M
M
12 Fan Coil FC600 Instruction Manual
The Hand icon indicates that the thermostat is in permanent override(manual
mode). The heat icon indicates that the thermostat is in Heating Mode. You can set a
temperature higher than the current temperature and the Fan Coil will maintain it until
you set a new setpoint.
The Leaf icon indicates that the thermostat is in Eco Mode. The heat icon indicates that
the thermostat is in Heating Mode. When in Eco Mode, the thermostat will use Eco
setpoint to control room temperature. You cannot change the temperature in Eco Mode.
The A Icon indicates that the thermostat is running in auto heat/cool changeover
mode. The hand icon shows Permanent Override Mode (manual). You can set a
setpoint temperature and the thermostat will follow it. The Heating/Cooling mode
will be selected automatically:
- using Heat / Cool changeover sensor connected to S1/COM (available in 2 pipe and
4 pipe application)
- using the pipe sensor connected to S1/COM (available in 2 pipe application only)
- using the "dead zone" (available in 4 pipe application only)
Eco Mode with auto heat/cool changeover. The temperature will be set using Eco
temperature setpoint. When in Eco Mode, the thermostat will use Eco set point to
control room temperature. You cannot change the temperature in Eco mode.
or .