–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
below.
–
Place the handlebar support in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
S02164-10
Screw, handle-
bar support
TUNING THE CHASSIS 11
1
. Take off the handlebar clamp. Remove
2
. Remove handlebar support
4
and push through nuts
2
.
M10
45 Nm (33.2 lbf ft)
3
.
5
from
Loctite
®
243™
95