Configuration Example - HP FlexNetwork 10500 Series Security Configuration Manual

Task
Display ARP attack entries detected by source
MAC-based ARP attack detection (in
standalone mode).
Display ARP attack entries detected by source
MAC-based ARP attack detection (in IRF
mode).

Configuration example

Network requirements
As shown in
send a large number of ARP requests to the gateway, the gateway might crash and cannot process
requests from the clients. To solve this problem, configure source MAC-based ARP attack detection
on the gateway.
Figure 125 Network diagram
ARP attack protection
Host A
Configuration considerations
An attacker might forge a large number of ARP packets by using the MAC address of a valid host as
the source MAC address. To prevent such attacks, configure the gateway in the following steps:
1. Enable source MAC-based ARP attack detection and specify the handling method as filter.
2. Set the threshold.
3. Set the lifetime for ARP attack entries.
4. Exclude the MAC address of the server from this detection.
Configuration procedure
# Enable source MAC-based ARP attack detection, and specify the handling method as filter.
<Device> system-view
Figure 125, the hosts access the Internet through a gateway (Device). If malicious users
IP network
Host B
Command
display arp source-mac { slot slot-number | interface
interface-type interface-number }
display arp source-mac { chassis chassis-number slot
slot-number | interface interface-type interface-number }
Gateway
Device
Host C
433
Server
0012-3f 86-e 94c
Host D