Configuring Extended Re-Dhcp Portal Authentication - HP FlexNetwork 10500 Series Security Configuration Manual

Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
BAS-IPv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
Before passing portal authentication, a user that uses the HPE iNode client can access only the
authentication page http://192.168.0.111:8080/portal. All Web requests from the user will be
redirected to the authentication page.
•
The user can access the resources permitted by ACL 3000 after passing only identity
authentication.
•
The user can access Internet resources permitted by ACL 3001 after passing both identity
authentication and security check.
# After the user passes identity authentication and security check, use the following command to
display information about the portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
VPN instance: --
MAC
0000-0000-0000
Authorization information:
DHCP IP pool: N/A
ACL: 3001
CAR: N/A

Configuring extended re-DHCP portal authentication

Network requirements
As shown in
obtains an IP address through the DHCP server. A portal server acts as both a portal authentication
server and a portal Web server. A RADIUS server acts as the authentication/accounting server.
Server name
--
IP
2.2.2.2
Figure 58, the host is directly connected to the switch (the access device). The host
Mask
Mask
VLAN Interface
100 Vlan-interface100
171
Action
--
Prefix length
Prefix length