Configuring Cross-Subnet Portal Authentication - HP FlexNetwork 10500 Series Security Configuration Manual

Hide thumbs Also See for FlexNetwork 10500 Series:
Table of Contents

Advertisement

Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
BAS-IPv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HPE iNode client or a Web browser. Before
passing
the
http://192.168.0.111:8080/portal. All Web requests from the user will be redirected to the
authentication page. After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
VPN instance: --
MAC
0015-e9a6-7cfe
Authorization information:
DHCP IP pool: N/A
ACL: N/A
CAR: N/A

Configuring cross-subnet portal authentication

Network requirements
As shown in
Switch B. A portal server acts as both a portal authentication server and a portal Web server. A
RADIUS server acts as the authentication/accounting server.
Configure Switch A for cross-subnet portal authentication. Before passing the authentication, the
host can access only the portal Web server. After passing the authentication, the user can access
Internet resources.
Server name
--
authentication,
the
IP
20.20.20.2
Figure
56, Switch A supports portal authentication. The host accesses Switch A through
Mask
user
can
access
VLAN
Interface
100
Vlan-interface100
165
Action
--
Prefix length
Prefix length
only
the
authentication
page

Advertisement

Table of Contents
loading

Table of Contents