Mira Excel Installation & User Manual page 35

1.7 Turn the shower on. Rotate the
temperature spindle until the required
temperature is obtained. Turn the
temperature spindle anticlockwise to
increase the temperature or clockwise
to decrease the temperature. If
resistance is felt DO NOT USE
FORCE to rotate the spindle as this is
the maximum
temperature from the shower control
with the available hot water supply
temperature. FORCE will DAMAGE
the internal components of the
cartridge assembly.
Note! It may be easier to put the hub
back onto the spindle to enable you to
turn it.
1.8 Turn off the shower.
1.9 Refit the temperature hub so that the
two small lugs on its front, align with
the arrows on the top and bottom on
the temperature indicator trim as
shown, ensuring that the stop on the
rear of the hub is at the 12 O'clock
position.
1.10 Rotate the temperature hub clockwise
approximately 90 degrees as shown
and refit the securing screw and the
temperature knob. Check that the
temperature knob can be rotated fully
in both directions, approximately 3/4
of a full turn (i.e. full cold to hot set
temperature).
1.11 Turn the shower on. Check the
temperature is correct and the override
functions correctly. If necessary repeat
the procedure until the correct
temperature is achieved.
obtainable
35
Anticlockwise to
increase
temperature
Arrows
Stop
Temperature Hub
Securing Screw
Clockwise to
decrease
temperature
Rear Face of Hub
Stop
Lug
Front Face of Hub
Temperature
Hub