Mira Excel Installation & User Manual page 21

2.26 Use a suitable screwdriver to tighten
the two screws in the backplate. The
screws will hold the shower control in
position.
2.27 Install the hot and cold supply pipes
38 mm from the finished wall at
150-155 mm centres.
Use the installation template to ensure
the pipes are in the right position.
2.28 Follow the installation instructions
2.11. to 2.15. inclusive.
2.29 Refer to section: Reversed Inlet
Connections
installation instructions 1.2. to 1.10.
inclusive. This will put the cartridge
assembly, the indicator trim and the
temperature knob in the correct
orientation for hot left and cold right
inlet supplies.
Note! For falling supplies where the hot
and cold inlet pipes have been
reversed, only the indicator trim and
the temperature knob need to be
removed and reinstalled the correct
way up. Refer to section: Reversed
Inlet Connections.
2.30 Turn on the water supplies and check
for any leaks.
Shower fittings
2.31 Install the shower fittings. Refer to the
Installation and User Guide for the
shower fittings.
and follow the
Compression Nut
Olive
Installation
Template
21
Backplate