Mira Excel Installation & User Manual page 18

2.5 Use the O-Key or a suitable
screwdriver to remove the blanking
plugs from the rising supply inlets.
2.6 Use the O-Key to remove the inlet
nipple bolts from the rear supply inlets.
2.7 Remove the inlet nipples.
2.8 Align and fit the inlet nipples, complete
with 'O' seals, into the rising supply
inlets.
2.9 Fit and tighten the inlet nipple bolts with
the O-Key.
Note! The nipple will still float when
the bolt has been tightened.
2.10 Screw the blanking plugs, complete
with washers into the rear supply inlet
nipple holes. Tighten the blanking plugs
using the O-Key or suitable
screwdriver.
2.11 Locate the Excel shower control on to
the backplate.
2.12 Use a suitable screwdriver to tighten
the two screws in the backplate. The
screws will hold the shower control in
position. Do not overtighten the
screws.
Inlet Nipple
Bolts
Inlet Nipples
Washer
O-Key
Blanking Plugs
'O' Seal
O-Key
18
Blanking Plugs
Washers
Inlet Nipples
Inlet Nipple
Bolts