3.20 When the plaster/tiles have set,
remove the screws and pull the entire
building-in shroud away.
Note! Retain the screws for later use.
3.21 Remove the backplate from the
concealing plate. Remove the
protective film from foam seal and fit
in position with the four fixing screws
(supplied).
Do not overtighten the screws.
Note! If the finish is particularly uneven
(i.e. due to grout lines), apply a small
amount of silicone sealant to ensure a
seal .
3.22 Fit the shroud and concealing plate
over the backplate.
Firmly push the concealing plate
until it clips into position.
Shroud
Concealing Plate
26