Mira Excel Installation & User Manual page 15

1.5 Use a spirit level and pencil to mark
the route of the hot and cold water
supply pipes at 150-155mm centres.
Note! The Excel is supplied with inlet
connections hot left, cold right and
bottom outlet as standard. For
installations with reversed hot and cold
supplies complete the installation and
refer to section: Reversed Inlet
Connections.
1.6 Remove the plaster and brick/block to
the required depth to conceal the
pipework.
Note! Depth must be sufficient to
prevent pipe concealing plates fouling
on the plumbing elbows.
1.7 Install the supply pipes. The pipes
must project 18 mm from the finished
surface of the wall at 150-155mm
centres.
Note! Use the installation template to
ensure pipes are in the right position.
1.8 Finish the surface of the wall as
required. The recesses from which
the pipes emerge must also
accommodate the 32 mm diameter x
10 mm deep flanges on the pipe
concealing plates.
1.9 Fit the pipe concealing plates over the
hot and cold supply pipes.
150-155 mm
Centres
15
18 mm from
finished wall
surface
32 mm
Dia
Concealing Plates