Ups Events Log - socomec NET-VISION Operating And Installation Manual

21.3. UPS EVENTS LOG

All incoming and out coming alarms detected by NET VISION are stored in the UPS events log.
UPS Events Log
Event Time (dd/mm/yyyy hh:mm:ss)
01/01/1970 00:00:00
Clicking on  changes the display order: by date and time or by severity level.
List of UPS event stored by NET VISION
UPS Imminent Stop
Overload Alarm
Ambient Temperature Alarm
Transfer locked
Transfer impossible
Insufficient resource
Redundancy lost
Output Short circuit detection
Maintenance Alarm
Remote Service Alarm
General Alarm
Battery disconnected
Battery discharged
End of Backup Time / Battery Low
Operating on Battery
Battery Temperature Alarm
Battery Room Alarm
Battery Test failed
Battery Alarm
Rectifier Critical Alarm
Rectifier Preventive Alarm
Rectifier Input Supply not OK
Gen Set Alarm
Charger Critical Alarm
Charger Preventive Alarm
Inverter Critical Alarm
Inverter Preventive Alarm
Bypass Critical Alarm
Bypass Preventive Alarm
Bypass Input Supply not OK
Phase Rotation fault
Maintenance Bypass Alarm
FAN Failure
NET-VISION 7 - SOCOMEC
from dd/mm/yyyy
Log count per page
<< < 1 2 3 > >>

Parallel system only
Parallel system only
If function present
If function present
If function present
If function present
Rectifier General Al.
If function present
Charger General Al.
Inverter General Al.
Bypass General Al.
to dd/mm/yyyy
5
Event Description
Event Level 
Information
'has been removed'
Warning
when the alarm disappears
Critical
UPS Power Off
Wrong Configuration
Internal / Communication failure
Option Board Alarm
External Input 1 to 4 Alarm
Unit 1 to 12 General Alarm
UPS connected
UPS not connected
Power Plugs 1 to 4 ON
Power Plugs 1 to 4 OFF
Transfer Load to Bypass
Transfer Load to Inverter
Enable eco mode
Disable eco mode
Enable standby mode
Disable standby mode
Alarm Acknowledgement
On maintenance bypass
Auto-test in progress
Battery test in progress
Load protected by Inverter
Normal mode
UPS in eco mode
Load on bypass
Unit Available
On standby
Load off
UPS shut off sent
Standby schedule sent
Eco mode schedule sent
If function present
If ADC programmed
Parallel system only
If power share plugs present
If power share plugs present
UPS STATUS EVENTS
GB 55