Shutdown Management - socomec NET-VISION Operating And Installation Manual

17.8. SHUTDOWN MANAGEMENT

Net Vision allows you to send notification and shutdown commands to servers. The shutdown
agent must be installed on each server / Host. The Net Vision IP address should be set in the
agent configuration. If the server is recognised by NET VISON, it will be present in the Client Ta-
ble page of the UPS monitoring menu.
ups shut off
This function is available if the Standby Schedule function is managed by the UPS. Otherwise
this function is not displayed.
The UPS shut-off command is sent to the UPS when the Net Vision sends the shutdown com-
mand to the server. This command is sent with the time period set for this function. The UPS will
turn off the output at the end of the time period.
The restart delay defines the time period after which the UPS should restart automatically after
mains power resumes. A restart time set to 0 means that the UPS will not restart.
Shutdown Management
UPS Shut Off Delay (Sec)
UPS Shut Off
UPS On Delay (mn)
Level of battery capacity (%)
Shutdown Event
List of Event
WARNING!
Make sure that the UPS shut-off time period is longer than the total time period for the shutdown
procedure for the Server / Hosts supplied by the UPS. See shutdown process paragraph for more details.
34 GB
Shutdown Actions
Disabled

Enabled
Disabled

Enabled
0 - 100
Warning Period 1st Warning
(Min) (Sec)
Delay in minutes Delay in seconds
before sending before sending the
shutdown command first warning mes-
to server sage to sever
Request to shut off the
UPS after delay
Request to restart the
UPS
Set the battery level for
event shutdown
Warning Interval
(Sec)
Delay between
2 warning mes-
sages sent to
server
NET-VISION 7 - SOCOMEC