socomec NET-VISION Operating And Installation Manual page 23

13.1.5. UNIT / UPS PARAMETERS TABLE
The table is updated with data read from the UPS or from the Unit selected
" UPS Status "
The status displayed depends on the type of UPS
range. Status lists are not available for all UPS, de-
pending on the range and UPS functionalities
"Output load rate
"Output Power
"Output Voltage
"Rectifier voltage
"Battery capacity
"Remaining backup time
"Battery voltage
"Temperature
"date / time"
"EMD temperature (°C)"
"EMD humidity (%)"
"EMD Alarm 1"
"EMD Alarm 2"
NET-VISION 7 - SOCOMEC
"UPS or Unit Parameters"
(%)"
(kVA)"
(V)"
(V)"
(%)"
(mn)"
(V)"
(°C)"
"EMD Parameters"
"Unknown" – no communication with UPS
"In Service mode"
"On maintenance bypass"
"Imminent STOP"
"Auto-test procedure"
"Operating on Battery"
"Battery test in progress"
"Load protected by Inverter"
"Normal mode" – for OFF LINE UPS
"UPS in eco mode"
"Load on Bypass"
"Unit Available"
"On standby"
"Load OFF"
Per phase
Per phase if measurements available from UPS
Per phase
Per phase
Only if battery present
UPS ambiance temperature
Only if "EMD" device is connected to NET VISION
GB 23