Exchanging The Electronics Module; Software Update - Vega VEGABAR 51 Operating Instructions Manual

8 Maintenance and fault rectification
Fault messages via the
indicating/adjustment
module
Reaction after fault rec-
tification
50
?
E013
no measured value available
l
à Exchange instrument or return instrument for repair
?
E017
Adjustment span too small
l
à repeat with modified values
?
E036
no operable sensor software
l
à Carry out a software update or send the instrument for repair
?
E041
Hardware error, electronics defective
l
à Exchange instrument or return instrument for repair
?
E113
Communication conflict
l
à Exchange instrument or return instrument for repair
Depending on the failure reason and measures taken, the steps
described in chapter "Set up" must be carried out again, if necessary.

8.3 Exchanging the electronics module

In case of a defect, the electronics module can be exchanged by the
user against an identical type. If no electronics module is available on
side, the module can be ordered for the VEGA agency serving you.
Ordering and exchange are possible with or without sensor serial
number. The electronics module with serial number includes order-
specific data such as factory setting, seal material etc. These are not
included in the electronics module without serial number.
The serial number is stated on the type label of VEGABAR 51 or on the
delivery note.

8.4 Software update

The software version of VEGABAR 51 can be determined as follows:
via the type label of the electronics
l
via the indicating and adjustment module
l
via PACTware
l
10)
Fault message can also appear if the pressure is higher than the nominal
range.
10)
VEGABAR 51 • Profibus PA