Installation Of Machine - SunStar SPS/B-1507 Series User Manual

3. Installation of machine

1) How to attach presser plate sheet
Attach the presser plate sheet on the side
which slider base and presser plate are met
as shown the Picture.
2) How to control slider base sag
Change the presser plate and the slider base
holder to adjust and assemble clamp cylinder
for sewing material. Then adjust oil sag for
feed between the feed bracket and the presser
plate.
3) How to change reversal presser plate
When the reversal presser plate is required to
change following the change of the size of
sewing material, loosen the screw for reversal
presser plate (two screws) to change the
plate. Then reassemble the presser plate.
(Tools: ' ─' shaped driver / size of screw: 9/64" n=40
•Reversal presser plate is applied in a size of the
minimum sewing material when delivered. Please
be noted that when a provisional presser plate is
placed, interference between the foot presser and
Caution
the reversal presser base occurs
4) How to adjust the position (height) of
reversal unit and upper feed plate
When the position (height) of upper feed
plate and reversal presser plate is required to
change, loosen and adjust screw of feed plate
clamp and reversal base.
7 7 1 1 6 6
17.8mm
2mm
①
presser plate
clamp cylinder for sewing material
reversal presser base
Adjustment of
height of reversal unit
(Presser plate)
Adjustment of position
(front and rear) of
reversal unit
(Presser plate)
To the face plate presser
plate
2mm
②
Presser plate sheet
[ Fig. 23 ]
slider base/holder
Screw for clamp cylinder for
sewing material (Adjusting oil
sag between slider base/
presser plate)
[ Fig. 24 ]
reversal presser plate
screw for reversal
presser plate
[ Fig. 25 ]
Adjustment of
height of upper
feed plate.
[ Fig. 26 ]