Adjusting The Label Guide; Removing The Inverting Clamp Devices - SunStar SPS/B-1507 Series User Manual

6. Adjusting the Label Guide

1) Attach the label guide as seen in the fig. 19.
In case of using label guide, attach the accessory sponge to the lower part of up-feed plate.
Caution
2) After unfastening the fixing screw ①, adjust the position of label guide (A) to fit with the
left end of label, then fasten the fixing screw ①.
3) After unfastening the fixing screw ②, adjust the position of label guide (B) to fit with the upper
end of label, then fasten the fixing screw ②.
In case of using small sized label, use the label guide (C) since the label guide (A) can be
interfered with the reversal devices.
Caution

7. Removing the Inverting Clamp Devices

1) Remove the inverting clamp devices when using the standard specification or adjusting X-Y
preciously.
2) Remove the inverting air tubes ① and ②, and one-tough juncture from the straight union.
3) After unfastening the fixing screw, take off the inverting clamp devices (unit).
②
Label Guide(C)
①
②
①
Label Guide(A)
Upper Feed Plate
Label Guide(B)
Yellow
①
Straight Union
[ Fig. 20 ]
Black
②
[ Fig. 21 ]
7 7 1 1 3 3