Adjusting The Wiper Parts - SunStar SPS/B-1507 Series User Manual

2. Adjusting the Wiper Parts

1) Unfasten the crank fixing screw① when a needle is stopped upward.
2) Adjust the wiper crank ② for wiper and needle to be apart from about 40mm.
3) Fasten the wiper crank fixing screw ①.
4) Unfasten the wiper fixing screw ③ and adjust it for wiper tail and needle tip to be apart from
about 1mm, then fasten the wiper fixing screw ③.
If a position of wiper is not proper, the wiper can be interfered with needle or inverting clamp
devices during operating, therefore, precise operation can not be a chieved.
Caution
①
②
5) For using the wiper, press the wiper operation
switch ① and for not using it, press the wiper
operation switch
7 7 6 6
①.
②
↓
1mm
Wiper On/Off Switch ①
Wiper Off
Wiper ON
③
40mm
[ Fig. 5 ]
7 7 1 1 0 0
[ Fig. 6 ]