Pager/Code Squelch - Icom IC-V8 Instruction Manual

10

PAGER/CODE SQUELCH

D D Code programming
An ID code MUST be programmed into code channel C0. Up to 6
transmit codes are programmable into code channels, C1 to C6, if
required.
q Push [ •
] after [A•
OPTION
• Pager mode is selected.
• 100 MHz digit shows "P."
w Push [8•
] after [A•
SET
• One of "CP" or "C0" to "C6" flashes.
• "C0" is the ID code and "C1" to "C6" are
transmit code.
e Rotate [VOL] to select code channel C0.
• A different ID code must be programmed into each transceiver.
r Enter the desired 3-digit ID code via the
keypad.
t Rotate [VOL] to select a transmit code
channel from C1 to C6.
y Enter the desired 3-digit transmit code via
the keypad.
u Push [6•
] after [A•
SKIP
set the channel for "receive inhibit" or "re-
ceive accept."
• When "receive inhibit" is set, "SKIP" ap-
pears as at right.
• Code channel C0 cannot be set as "receive inhibit."
• See the following table for "receive accept" and "receive inhibit" de-
tails.
i Repeat steps t and y to set additional transmit code channels,
if desired.
o Push [#•
] or [PTT] to exit code set mode.
ENT
41
] is pushed.
FUNC
F
MR
] is pushed.
FUNC
F
MR
F
MR
F
MR
] is pushed to
FUNC
F SKIP
MR
• Receive accept/receive inhibit
"Receive accept" ("SKIP" indicator does not appear) accepts
pager calls when the transceiver receives a signal with a code
the same as that in the code channel.
"Receive inhibit" ("SKIP" indicator appears) rejects calls even
when the transceiver receives a code the same as that in the
TX
code channel. Transmit codes should therefore be programmed
for "receive inhibit," otherwise the transceiver will not reject un-
necessary calls.
TX
• Pager/code squelch operation during channel indication
To use these functions in channel indication, the pager/code
squelch setting must be programmed with other memory contents
before selecting channel number indication.
TX
TX
TX
10
PAGER/CODE SQUELCH
42