Memory Programming; General; Programming The Memory/Call Channels; Channel Name Programming - Icom IC-V8 Instruction Manual

6

MEMORY PROGRAMMING

General

The transceiver has 100 memory channels (plus 3 pairs of scan
edges and 1 call channels) for storage of often-used frequencies.
D Memory channel contents
The following information can be programmed into memory:
• Operating frequency
• Duplex direction (+ or –) with an offset frequency (pgs. 21, 22)
• Subaudible tone encoder or tone squelch ON/OFF (pgs. 21, 35)
• Subaudible tone and tone squelch frequencies (pgs. 22, 36)
• Skip information* (p. 32)
*Except for scan edge channels.
Programming the memory/call
channels
q
Push [D• ] to select VFO mode, if necessary.
CLR
w
Set the desired frequency.
e
Set other informations such as tone, duplex, etc. as desired.
r
Push [C• ] for 1 sec. (until emits 3 beeps) after pushing
MR
[A• ] to program the information into the displayed memory
FUNC
channel and return to VFO
• Continue to hold [C•
sec. after 3 beeps emission, to incre-
ment displayed memory channel
.
number
25
] down for 1
MR
MR

Channel name programming

q
Select a channel name indication type in
(pgs. 20, 51).
w
Push [C• ] to select memory mode, if necessary.
MR
e
Push [8• ] after pushing [A•
SET
programming mode.
• A currently editing character is flashed.
t
Rotate [VOL] to select a character.
y
Push [Y] to move to the right, [Z] to move to the left.
• Up to 5-digit channel names can be programmed.
• Usable character are; A–Z, 0–9, "space", +, –, =, , /, [, and ].
u
Push [#• ] to fix and exit channel name programming
ENT
mode.

Memory transferring

Memory (call) channel contents can be transfer to VFO or to an-
other memory channel.
D Memory/call
VFO
q
Select the memory (call) channel to be transferred:
Push [C• ] ([ B• ]) to select memory (call) mode.
MR
CALL
Push [Y]/[Z] to select the memory channel.
• When "dial" is assigned [VOL], rotate [VOL] to select the memory
channel. (p. 51)
w
Push [C• ] for 1 sec. after pushing [A•
MR
lected memory contents to the VFO.
• VFO mode is selected automatically.
MEMORY PROGRAMMING
INITIAL SET MODE
] to enter to channel name
FUNC
] to transfer the se-
FUNC
6
26