Pager Operation - Icom IC-V8 Instruction Manual

10
PAGER/CODE SQUELCH

' ' Pager operation

D Calling a specific station
q Program the needed code channel in advance (p. 41).
w Set the operating frequency.
• Set the AF and squelch to the desired level as the normal operation.
e Push [ •
] after [A•
OPTION
• Pager mode is selected.
• 100 MHz digit shows "P."
r Select the desired transmit code channel:
Push [8• ] after [A•
SET
Rotate [VOL] to select the desired code channel.
Push [#• ] to return to previous condition.
ENT
t Push [PTT] to transmit the pager code.
y Wait for an answer back.
• When the transceiver receives an answer back code, the function
display shows the other member's ID or group code.
u After confirming a connection push [ •
pushed to select code squelch operation, or repeat previous key
operation again to select non-selective calling system.
• DO NOT push any digit keys while code channels C0 to C6 are dis-
played, or code channel contents are changed.
i Communicate with the other party as normal: push [PTT] to
transmit; release to receive.
43
Optional UT-108 required
] is pushed.
FUNC
F
MR
] is pushed.
FUNC
] after [A•
OPTION
D Waiting for call from a specific station
q Set the operating frequency.
w Push [ •
OPTION
• 100 MHz digit shows "P."
e Wait for a call.
• When receiving a call, the caller's ID or group code appears as
shown below.
TX
• DO NOT push any digit keys while code channels C0 to C6 are dis-
played, or code channel contents are changed.
r Push [PTT] to send an answer back call and display the operat-
ing frequency.
t After confirming a connection push [ •
pushed to select code squelch operation, or repeat previous key
operation again to select non-selective calling system.
• PERSONS CALLS
This display appears when you are called
] is
FUNC
with your ID code and the calling station's ID
code is 123.
• GROUP CALLS
This display appears when you are called
with the group code, 888, and 888 has been
programmed into code channel C6.
• ERROR INFORMATION
When the transceiver receives an incomplete
signal, "E" and previously received code ap-
pear.
PAGER/CODE SQUELCH
] after [A• ] is pushed.
FUNC
OPTION
F
CP and
F
F
Previously received
10
] after [A• ] is
FUNC
SKIP
TX
MR
flash.
Code channel
TX
MR
TX
MR
code.
44