Preliminary Procedure - LeCroy AP034 Instruction Manual

Description
BNC coaxial cable
(2 required)
BNC Tee Adapter
Banana Plug Adapter
(2 required)
Shorting Plug
Adjustment Tool
Low Capacitance
Screwdriver
If a LeCroy ProBus equipped oscilloscope is not available, you may perform the adjustment
procedure with an alternate oscilloscope that meets the other Minimum Specifications, and the
PRGHO $'336 SRZHU VXSSO\ 7KH LQSXW WHUPLQDWLRQ RI WKH RVFLOORVFRSH PXVW EH VHW WR 
offset or position must remain at center screen, and the high-frequency adjustments must be
performed with the ADPPS connected directly to the input of the oscilloscope.

PRELIMINARY PROCEDURE

²
TABLE 4. Test Equipment and Accessories
Minimum Specifications
male-male BNC, approx. 1 m
female-male-female
BNC female-to-dual male
banana plug
Two 0.025 in. square pins on
0.100 in. centers
0.025 in. square tip
* Notes
1. Using pliers, carefully remove each of the push buttons from
the ProBus interface housing by gently pulling them away
from the housing.
2. Remove the two screws that secure the plastic cover on the
cable end of the ProBus interface housing. Gently pull on the
probe cable to slide the circuit board assembly from the metal
housing.
3. Remove the 5/64 in. (2 mm) Allen head cap screw from the
small cover on the back of the probe tip. Remove the cover
along with the small cover on the opposite side of the probe.
Hold the shielded portion of the probe head in one hand and
ISSUED: January 2000
$3 $FWLYH 3UREH
Test Equipment Examples
Pomona 5697-36
Pomona 3285
Pomona 1269
Supplied with AP03X-CF01
Johanson 4192
AP034-OM-E Rev D
 WKH