Symantec NetBackup 5330 Hardware Installation Manual page 66

Adding the disk space of an Expansion Storage Shelf from the NetBackup Appliance Shell Menu
To add the disk space of an expansion shelf from the NetBackup Appliance Shell
Menu
1 Use PuTTY to start an SSH session to access the NetBackup Appliance Shell
Menu.
Note: You can also connect a laptop, keyboard and monitor, or KVM to the
appliance to access the NetBackup Appliance Shell Menu.
2 Log in to the NetBackup Appliance Shell Menu. The Main_Menu prompt
appears.
3 Navigate to the Monitor menu as follows:
Enter
Monitor
4 Type
Hardware ShowHealth
Information about the system appears. Browse to the Primary Storage Shelf
to Expansion Storage Shelf Connection information. The Status column
should say Connected.
5
At the prompt, type return to return to the Main menu.
6 Perform a scan as follows:
At the Main_Menu prompt, type
■
Type
■ Storage
Type
■
Scan
The scan takes a couple of minutes to complete.
7 View the available storage space as follows:
Navigate to the Storage menu.
■
At the prompt, type
■
Note that you can add the disks with status New Available.
8 From the Storage menu, enter
are in a New Available state and can be added. Copy a disk ID that is
displayed.
9 At the prompt, enter add <disk ID> and press
that you copied.
Repeat step
10 View the available storage space as follows:
and press .
Enter
and press
and press
Enter
and press .
Enter
Show Disk
Add
8 and 9 to add each disk ID that is displayed.
Adding an Expansion Storage Shelf
.
Enter
and press
Manage Enter
.
and press .
Enter
and press . It displays the disks that
Enter
. <disk ID> is the disk ID
Enter
66
.