Table of Contents
Advertisement
4
At the rear upper RU of the rack, insert the rear of the rail into the top and the
bottom holes of the RU.
5
Extend the rail toward the front of the rack and insert it into the top and the
bottom holes of the RU.
6
Repeat steps
4
and
7
Make sure that both rails are parallel and secure.
8
Fully extend both rails forward until the release buttons click.
9
Carefully lift the appliance and tilt the rear down towards the back of the rails.
10
Locate the slots at the back of each rail.
5
to install the right rail.
RIGHT
Hardware installation procedures
Installing the NetBackup 5330 appliance
39
Advertisement
Table of Contents
Need help?
Do you have a question about the NetBackup 5330 and is the answer not in the manual?