Control Sticks Length Adjustment; Neutralizing The Control Sticks - GRAUPNER mz-10 HoTT S1001 User Manual

Control sticks length adjustment

Neutralizing the control sticks

14 / 40
Open step by step:
Before opening the housing switch the transmitter off.
Open the battery case.
Remove the battery box lifting it from one side and gently release
it from the velcro tape.
Unplug the connector.
Unscrew the eight screws with a cross screwdriver.
Hold both housing halves with both hands and let the screws
fall on a proper surface turning the transmitter upside-down.
Rotate the lower half carefully and fold it to the bottom.
Note
Cables connect the lower half of the housing with the upper part
electronic components. This connection must not be damaged! Do
not touch the electronic boards.
Closing step by step:
Check if the upper and the lower part of the transmitter housing
are correctly coupled and the tiny cables are properly placed.
Screw the housing screws in their shrouds.
Reconnect the battery box.
Length of both control stick can be adjusted. Hold down the
bottom half of the knurled grip, and loosen the screwed connec-
tion by turning the top part:
You can now lengthen or shorten the control stick by screwing
it up or down. Then clamp the top and bottom part of the grip
by rotating them against each other.
Neutralizing step by step:
Locate in the left control stick gimbal the screw surrounded by
a white circle in the picture.
Turn the screw toward the inside of the transmitter until the rel-
evant control stick can move freely from stop to stop, or turn it
outward until the control stick resets itself independently.
S1001_jp_V1