Ethernet Interface (X1) - Siemens CP 1243-7 LTE Operating Instructions Manual

User names and passwords can contain up to 64 characters. You will find the characters
permitted in the section Permitted characters in the configuration (Page 103).
"List of preferred networks"
In this parameter group, you specify the dial-in behavior of the CP into various mobile
wireless networks.
"TeleService settings"
In this parameter group, you specify the connection parameters for the TeleService
server(s).
You will find an overview of configuration for TeleService and more information on this topic
in the section TeleService (Page 127).
4.7

Ethernet interface (X1)

The Ethernet interface
The CP does not have a physical Ethernet interface.
In STEP 7, the Ethernet interface is used as a placeholder for the configuration of various
address and monitoring parameters.
Ethernet addresses
Enter you configure IP address of the CP and, if applicable, the network connection.
If you enable security functions, for example when using telecontrol communication, for
reasons of consistency you need to network the CP. To do this create any Ethernet network.
● Dynamic IP address
Enable this option if the CP is assigned the IP address dynamically by the network
provider.
● Fixed IP address from the mobile wireless network provider
Enable this option if you have a mobile wireless contract with which the network provider
assigns the CP a fixed IP address.
This is necessary when using S7 communication and receiving data via Open User
Communication.
Time-of-day synchronization
For the configuration of the time-of-day synchronization read the section Time-of-day
synchronization (Page 47).
CP 1243-7 LTE
Operating Instructions, 04/2017, C79000-G8976-C381-03
Configuration
4.7 Ethernet interface (X1)
53