Siemens CP 1243-7 LTE Operating Instructions Manual page 102

Configuration
4.13 Messages
"Message parameter"
Here you configure the phone number or the recipient, the subject (e-mail) and the text of the
message.
"Trigger"
In the "Trigger" parameter group you configure triggering for sending the message and other
parameters.
● E-mail trigger / SMS trigger
Specifies the event for which the sending of the message is triggered.
– Use PLC tag
– CPU changes to STOP
– CPU changes to RUN
– Connection to a partner interrupted
– Connection to a partner established
– Connection establishment to partner failed
– Teleservice session started
– Teleservice session ended
– Weak mobile wireless network
● PLC tag for trigger
PLC tag for the trigger "Use PLC tag"
If the memory area of the trigger bit is in the bit memory or in a data block, the trigger bit
is reset to zero when the message is sent.
102
For the trigger signal to send the e-mail, the edge change (0 → 1) of the trigger bit
"PLC tag for trigger" is evaluated that is set by the user program. When necessary, a
separate trigger bit can be configured for each message. For information on the trigger
bit, see below.
Resetting the trigger bit:
If the memory area of the trigger bit is in the bit memory or in a data block, the trigger
bit is reset to zero when the message is sent.
In all other cases, you need to reset the trigger bit with the user program.
Triggers the sending of the message when the connection to a partner is interrupted.
Triggers the sending of the message when the connection returns.
Triggers the sending of the message when the connection to a partner could not be
established.
Only for SMS
If the mobile wireless connection for telecontrol communication is too weak, an SMS
message is triggered and sent to the configured recipient.
Operating Instructions, 04/2017, C79000-G8976-C381-03
CP 1243-7 LTE