Permitted Characters In The Configuration - Siemens CP 1243-7 LTE Operating Instructions Manual

● Enable identifier for processing status
If the option is enabled, every attempt to send returns a status with information about the
processing status of the sent message.
The status is written to "PLC tag for processing status". If there are problems delivering
messages, you can determine the status via the Web server of the CPU by displaying the
value of the PLC tag there.
For the significance of the status output in hexadecimal, refer to the section Processing
status of messages (Page 122).
● PLC tag for processing status
PLC tag of the type DWORD for the processing status
● Include value
If you enable the option, the CP sends a value for the placeholder $$ from the memory
area of the CPU in the message. To do this enter "$$" as a placeholder for the value to
be sent in the message text.
Select a PLC tag whose value will be integrated in the message. The value is entered in
the message text instead of the placeholder $$.
$$ can be a placeholder for data point types with a simple data type up to a size of 32
bits.
● PLC tag for value
PLC tag in which the value to be sent is written.
4.14

Permitted characters in the configuration

Character set for APNs, e-mail servers, message texts and the Telecontrol password
The following permitted characters apply to:
● APN:
User names and passwords
● SMTP server:
User names and passwords
● Messages in the message editor:
Message texts
● CP identification
Telecontrol password
CP 1243-7 LTE
Operating Instructions, 04/2017, C79000-G8976-C381-03
4.14 Permitted characters in the configuration
Configuration
103