Siemens CP 1243-7 LTE Operating Instructions Manual page 46

Simatic net
Table of Contents

Advertisement

Configuration
4.3 Information required for configuration
Note
Solution after entering an incorrect PIN:
To avoid the PIN being rejected by the CP again, use a PIN that is different from the
incorrectly entered PIN. Procedure:
• If the PIN of the SIM card was not changed:
– Configure the PIN in STEP 7 with the PIN of the SIM card.
– Reload the station.
• If the original PIN of the SIM card was changed externally to the PIN that was previously
incorrectly entered in STEP 7:
– Change the PIN of the SIM card externally to a new PIN that has not yet been
– Change the configured PIN in STEP 7 to the newly assigned PIN of the SIM card.
– Reload the station.
Information required for telecontrol communication
The following information is required for the STEP 7 configuration of the CP:
● Address of the telecontrol server
– IP address
– Name of the telecontrol server that can be resolved by DNS
– IPT listener port of the telecontrol server. Default setting: 55097
If only connections with TCSB are used (no direct communication), a dynamic IP address
can be assigned to the CP by the Internet service provider.
For addressing a redundant TCSB system, refer to the section Partner stations >
Telecontrol server (Page 57).
● DNS server address(es)
You require the DNS server address if you address the telecontrol server using a name
that can be resolved by DNS and the DNS is not operated by the network provider. You
configure DNS in the parameter group "DNS configuration":
– If you do not specify an address, the DNS server address is obtained automatically
– If you want to use a different DNS server, enter its IP address. In this case, DNS
CP parameter for configuring the telecontrol server
The following parameters from the STEP 7 configuration of the CP are also required for the
configuration of the telecontrol server:
● Address and port of the telecontrol server
● Project number
46
incorrectly configured in STEP 7.
or
from the network provider (recommended procedure).
servers of the network provider are not taken into account.
Operating Instructions, 04/2017, C79000-G8976-C381-03
CP 1243-7 LTE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S7-1200 telecontrolCp 1243-7 lte-euCp 1243-7 lte-us

Table of Contents