5/ Jumpers And Connectors; Hardware Configuration Setting - Kontron mITX-SKL-S-H110 User Manual

5/ Jumpers and Connectors

5.1. Hardware Configuration Setting

This chapter gives the definitions and shows the positions of jumpers, headers and connectors. All of the
configuration jumpers on the board are in the proper position. The default settings shipped from factory are marked
with an asterisk (*).
In general, jumpers on the board are used to select options for certain features. Some of the jumpers are designed to
be user-configurable, allowing for system enhancement. The others are for testing purpose only and should not be
altered. To select any option, cover the jumper cap over (SHORT) or remove (NC) it from the jumper pins according to
the following instructions. Here, NC stands for "Not Connect".
5.1.1. Jumpers and Connectors
Jumpers
CLR_CMOS1
COM9_SW1
COM9_SW2
LCD_PWR LCD
INTR
Connectors
CPU_FAN
SYS_FAN
FP
USB2_P1
SPK
GPIO
LCD_CTL
LVDS
ATX
PWR_CPU1
MINI-PCIE
PCIEx16X
SPI_SOCKET
SATA1
SATA2
SATA3
BAT1
DIMM1
DIMM2
Function
Clear CMOS
COM2 Pin 9 Setting
COM1 Pin 9 Setting
Power source selection
Case Open
Function
CPU FAN Connector
SYS FAN Connector
Front Panel Connector
USB 2.0 Connector
Speaker Connector
GPIO Port Connector
LCD Backlight Control Connector
LVDS Connector
ATX Power Connector
CPU Power Connector
Mini PCIe Connector
PCIe x16 3.0 Connector
Bios Socket
SATA3.0 Connector
SATA3.0 Connector
SATA3.0 Connector
Battery Socket
Memory Socket
Memory Socket
www.kontron.com
mITX-SKL-S/H110 – Rev. 1.1
Remark
1 x 3 header
2 x 3 header
2 x 3 header
1 x 3 header
1 x 3 header
Remark
1 x 4 wafer
1 x 4 wafer
2 x 5 header
2 x 5 header
1 x 4 wafer
2 x 5 box header
1 x 5 wafer
2 x 20 connector
2 x 10 Connector
2 x 2 Connector
Standard
Standard
Standard
CR2032 compatible
Slot
Slot
// 20