Intercharacter Delay; Usb-Com Interface Setup - Datalogic Magellan 3200VSI Reference Manual

USB-COM Interface Setup

Intercharacter Delay

One-half of the delay specified below is inserted between scancodes within each character. If the transmission speed is
too high, the system may not be able to receive all characters. You may need to adjust the delay to make the system
work properly. Selectable from 00 to 99 in 10msec increments.
To configure this feature, scan the "Enter/Exit Programming Mode" bar code above to place the unit in Programming
Mode, then the "Set Intercharacter Delay," followed by the two digits (zero padded) from the Alphanumeric table in
Appendix C,
representing your desired length. Exit programming mode by again scanning the "Enter/Exit Program-
ming Mode" bar code above/
USB-COM Interface Setup
The scanner has two USB-COM interfaces, USB-COM and USB-COM DL (Data-
logic). The Datalogic USB-COM driver works for both USB-COM interfaces.
Before plugging your scanner into the Host PC, please ensure you have already
copied the executable DLS USB-COM driver file to your PC and that the scan-
ner's interface is set to USB COM or USB COM DL. The DLS USB-COM driver is
provided by Datalogic or downloaded from the Datalogic website listed on the
back cover of this manual.
1. Execute the DLS USB-COM driver file.
2. When the scanner is first plugged into the PC, Windows will bring up the
3. The installation is complete.
Product Reference Guide
DEFAULT SETTING FOR THIS FEATURE:
00 (No Delay)
"Found New Hardware" message.
Enter/Exit Programming Mode
Set Intercharacter Delay
71