Single Cable Rs-232 Use Stx; Set Single Cable Rs-232 Stx Character - Datalogic Magellan 3200VSI Reference Manual

Single Cable RS-232

Single Cable RS-232 Use STX

Enables/disables the ability of the scanner to use STX.
Enable STX
DEFAULT

Set Single Cable RS-232 STX Character

This feature selects the STX character.
To specify the STX Character:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, SET SINGLE CABLE RS-232 STX CHARACTER below.
3. Scan the appropriate characters/digits from the keypad in Appendix that
4. The scanner will automatically exit Programming Mode when the appro-
Product Reference Guide
You'll need to cover any unused bar codes on this and the facing page to
ensure the scanner reads only the bar code you intend to scan.
represent the decimal designation for the desired character. A table con-
taining the ASCII Character Set and their corresponding hex values is
available in the inside back cover of this manual. ASCII parameters must be
input by scanning decimal digits for each character. Pad all numbers with
leading zeroes to yield a three-digit entry (001-127). Thus, to set a single
character value of A, bar codes containing the digits '0', '6' and '5' must
be scanned. The selectable range for this option is any decimal value from
001 to 127.
priate amount of digits have been scanned.
SET SINGLE CABLE RS-232 STX CHARACTER
Enter/Exit Programming Mode
Disable STX
61