Retry On Ack Nak Timeout; Ack Nak Timeout Value - Datalogic Magellan 3200VSI Reference Manual

RS-232 Interface Features

Retry on ACK NAK Timeout

Enables/disables retry after the configurable ACK NAK Timeout Value (set in the
following feature) has expired.
Enable Retry on ACK NAK Timeout
DEFAULT

ACK NAK Timeout Value

This item specifies the time the scanner will wait for an ACK character from the host following a label transmission.
00 = Infinite timeout
01 - 75 = Timeout in 200-millisecond increments
To configure this feature, scan the "Enter/Exit Programming Mode" bar code above to place the unit in Programming
Mode, then the "Set ACK NAK Timeout Value," followed by the two digits (zero padded) from the Alphanumeric table in
Appendix C,
representing your desired value. Exit programming mode by again scanning the "Enter/Exit Program-
ming Mode" bar code above.
Product Reference Guide
DEFAULT SETTING FOR THIS FEATURE: 01 (200 msec)
Enter/Exit Programming Mode
Disable Retry on ACK NAK Timeout
Set ACK NAK Timeout Value
55