Inserting A Pci Card; Changing The Bracket; Chapter 3 Installing The Client Adapter - Cisco Aironet CB21AG Installation And Configuration Manual

Chapter 3 Installing the Client Adapter
If the Found New Hardware Wizard window appears, click Cancel.
Step 4
Note
Go to the
Step 5

Inserting a PCI Card

You must perform the following procedures in the order listed below to insert a PCI card:
•
•
•
•

Changing the Bracket

The PCI card is shipped with a full-profile bracket attached. If the PC into which you are inserting the
PCI card requires the card to use a low-profile bracket, follow these steps to change brackets.
Step 1 Remove the two screws that attach the bracket to the card. See
Figure 3-2
1
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-05
If you do not click Cancel, the wizard will attempt to install software for the client adapter but
will be unable to find it.
"Installing the Client Adapter Software" section on page
Change the bracket (if required), see below
Insert the card, page 3-4
Assemble the antenna, page 3-5
Mount the antenna, page 3-6
Changing the PCI Card Bracket
1
1
Bracket screws
Inserting a Client Adapter
3-9.
Figure 3-2.
3-3