Cisco Aironet CB21AG Installation And Configuration Manual page 51

Chapter 3 Installing the Client Adapter
Check the Enable Cisco Aironet System Tray Utility (ASTU) check box if you want to be able to use
Step 31
ASTU even though you have chosen to configure your client adapter through a third-party tool instead
of ADU and click Next.
Step 32 When prompted to insert your client adapter, click OK. The Setup Status window appears (see
Figure
Figure 3-17
The installation process begins, and you are notified as each software component is installed.
When a message appears indicating that your computer needs to be rebooted, click OK and allow your
Step 33
computer to restart.
If the Windows Found New Hardware Wizard appears after your computer reboots, click Next, allow the
Step 34
wizard to install the software for the client adapter, and click Finish.
Step 35 If your network setup does not include a DHCP server and you plan to use TCP/IP, follow these steps
for your operating system.
• Windows 2000
a.
b.
c.
d.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-05
3-17).
Setup Status Window
Double-click My Computer, Control Panel, and Network and Dial-up Connections.
Right-click Local Area Connection x (where x represents the number of the connection).
Click Properties.
In the Components Checked Are Used by This Connection field, click Internet Protocol
(TCP/IP) and Properties.
Installing the Client Adapter Software
3-19